Z21- Rocrail: Bloques y Rutas

[rezjat]

Hola. Pues se me ocurren a bote pronto 2 cosas:

- El cable que sale del retro S88 no debiera estar conectado en "S88 OUT"?
- Has indicado al 4088 que tienes un módulo adicional conectado? Está en las instrucciones, que te pego aquí abajo.

A ver si es algo de esto...
Saludos.

1. Multiple modules (optional, see above):
2. Connect only (!!!) the DR4088RB to the R-Bus . The green LED next to the programming button blinks at a mode-rate pace (on-off-on-off).
3. Follow the procedure to program modules as described for the Roco 10787.
4. When the program asks you to disconnect the 10787 , press the programming button on the DR4088RB. The green LED will blink slower (long-off, short-on, long-off, short-on etc.)
5. Now press the button again. The green LED will blink at the same rate, but with a different pattern (long-on, short-off, long-on, short-off etc.).
6. Now enter the number of modules instead of the number for the module address. This number is the number of connected modules divided by two. For example, only one DR4088RB -> 2; 1 DR4088RB + 1 DR4088 s88 -> 4; 1 DR4088RB + 4 DR4088 s88 -> 10.
7. Continue the procedure for assigning the module address. The control unit now sends the number of modules to the R-Bus.
8. When the DR4088RB has received the number of modules, the LED will return to its initial blinking frequency: on-off-on-off-on-off etc.
9. Finish the procedure for programming Roco 10787s.